KB9050 Gun

[Forum Builder]

Machine Model Number - KB9050

Machine part number, found on silver sticker
(e.g. 1.***-***.0) - 1.396-513

Type of Enquiry - Enquiry on Parts

Message
I require a replacement trigger gun for my machine. Could you also advise if installation is straight forward as I could not get all the screws off of the old one. Don't seem to have same heads on them?

[Steve Perkins]

Hi. the guns are not made to be dismantaled, the hose is cliped in at the bottom of the gun,

the link below will take you to the gun needed

steve

http://www.cleanstuff.co.uk/cgi-bin/ss00...PR=-1&TB=A

[Forum Builder]

Thanks Steve- have looked at your site, however I still have a couple of
questions:
1. The gun shown appears to have the hose connector inside below the trigger, my
original gun has hole above the trigger at rear of gun, therefore will it still
connect to the hose and will attachments still fit it?
2. Your diagram shows the clip for the hose on it, is this supplied or do I need
to purchase it separately.
Regards

[Steve Perkins]

Hi Bill, they have moved the hose input on the new guns and the old ones will fit, the clips come with the new guns, all of your old attachments will fit as normal

steve

[devpaul]

I am looking to get one of these types can you tell me where can I get it from?

[Matty]

Hi,

The link below will take you to the part,

http://www.cleanstuff.co.uk/cgi-bin/ss00...PR=-1&TB=A